Arduino-based IR intervalometer for Sony Alpha/NEX cameras.
All cameras compatible with the RMT-DSLR2 remote:
- NEX-5T, NEX-6, NEX-7
- a6000, a6300, a6500
- a7, a7R, a7S (and Mark II/III variants)
| Component | Details |
|---|---|
| Arduino | UNO or Nano |
| IR Transmitter | Any 3-pin IR transmitter module (widely available on Amazon) |
| Wiring | VCC → 5V, GND → GND, Signal → Pin 9 |
Install via Arduino IDE Library Manager:
IRremote by shirriff, z3t0, ArminJo (v3+)
Edit the settings block at the top of the sketch:
Mode shootMode = BULB; // BULB or SINGLE
uint32_t bulbTime = 11; // Exposure time (s) — set 1s above target ~ not necessary
uint32_t intervalTime = 5; // Wait after shutter close (s)
int totalShots = 0; // 0 = infiniteOlder cameras (e.g. A200, A350) have slower image processing and may need intervalTime of 10s or more to avoid missed shots.
- Set camera to BULB mode (if using BULB)
- Enable Remote Ctrl in camera menu
- Point IR transmitter at the front of the camera
- Upload sketch and open Serial Monitor (9600 baud)
=== Sony IR Intervalometer ===
Mode : BULB
Exposure : 11s
Interval : 5s
Shots : inf
------------------------------
[Shot 1] Shutter open
Exposing: 11s
...
Shutter close
Next shot in: 5s
...
[Shot 2] Shutter open
...