Filter Pressure Sensor Issues

[Exit2Studios]

I have a 5v pressure sensor, but it's not passing the values to REM.

As you can see, Input 4 is showing 4+v, but in the Generic Device, no voltage or psi is showing up. I'm sure this is a simple fix and I'm just missing something, as I had this working in my previous setup.

[tagyoureit]

You have to feed from the source to the target. ie from the Sequent to the Transducer, not the way you have it. https://github.com/rstrouse/relayEquipmentManager/wiki/Temperature-Sensors#step-5-feed-your-temperature-probe

[Exit2Studios]

I have that wrong:

correct:

Thanks for the prompt...user error as usual :-)

[Exit2Studios]

Where should the positive and negative leads from the pressure transducer go (I'm using Mega-Bas hat and 8 relay hats, so all the pi pins are exposed). I'm assuming 5v and gnd, but not getting expected results. If I use the exposed "power" i/o, the voltage remains close to 5v regardless of the pressure, and if use the exposed pins on the BAS nothing.

[tagyoureit]

See #995 (reply in thread).